Filter
Top Products
9-3
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Chapter 9 Installing and Removing the ASA 5585-X IPS SSP
Specifications
another power supply module for a redundant power supply configuration. The SSP-10 with IPS SSP-10
has two CPUs, six DIMM modules, two embedded crypto accelerator, and two dual-port 10-GB uplinks
for the SFP/SFP+ interfaces.
ASA 5585-X SSP-20 With IPS SSP-20
The ASA 5585-X SSP-20 with IPS SSP-20 provides firewall, VPN support, intrusion prevention system
protection, and 20 interfaces (2 SFP/SFP+ and 18 copper Gigabit Ethernet). The SSP-20 with IPS
SSP-20 has one power supply module and one fan module. You can replace the fan module with another
power supply module for a redundant power supply configuration. The SSP-20 with IPS SSP-20 has two
CPUs, 12 DIMM modules, four embedded crypto accelerators, and two dual-port 10-GB uplinks for the
SFP/SFP+ interfaces.
ASA 5585-X SSP-40 With IPS SSP-40
The ASA 5585-X SSP-40 with IPS SSP-40 provides firewall, VPN support, intrusion prevention system
protection, and 20 interfaces (4 SFP/SFP+ and 16 copper Gigabit Ethernet). The SSP-40 with
IPS SSP-40 has one power supply module and one fan module. You can replace the fan module with
another power supply module for a redundant power supply configuration. The SSP-40 with IPS SSP-40
has four CPUs, 12 DIMM modules, six embedded crypto accelerators, and four dual-port 10-GB uplinks
for the SFP/SFP+ interfaces.
ASA 5585-X SSP-60 With IPS SSP-60
The ASA 5585-X SSP-60 with IPS SSP-60 provides firewall, VPN support, intrusion prevention system
protection, and 20 interfaces (4 SFP/SFP+ and 16 copper Gigabit Ethernet). The SSP-60 with
IPS SSP-60 ships with two power supply modules; however, the SSP-60 with IPS SSP-60 can function
with only one power supply module. Although the SSP-60 with IPS SSP-60 can also operate with only
one power supply module, we recommend that you install two power supply modules for extended
reliability since the power supply modules operate in load-sharing mode. If one fails in this
configuration, the other power supply module can still handle the full load until the failed power supply
module is replaced. The SSP-60 with IPS SSP-60 has four CPUs, 24 DIMM modules, eight embedded
crypto accelerators, and four dual-port 10-GB uplinks for the SFP/SFP+ interfaces.
Caution
If you remove a power supply or fan module, replace it immediately to prevent disruption of service.
Specifications
Table 9-1 lists the specifications for the ASA 5585-X IPS SSP.
Table 9-1 ASA 5585-X IPS SSP Specifications
Height 1.70 in
Width 17.00 in
Depth 15.50 in
Weight 11.50 lb
Temperature Operating 32 to 104°F (0 to 40°C)
Nonoperating -40°F to 167°F (-40°C to 75°C)
Relative humidity (noncondensing) Operating 10% to 90%
Nonoperating 5% to 95%