Filter
Top Products
5-44
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Chapter 5 Installing the IPS 4270-20
Installing and Removing Interface Cards
Step 8
To unlock the expansion card slot, push down on the center part of the blue tab and open the latch.
Step 9
To uninstall a card, lift the card out of the socket. To install a card, position the card so that its connector
lines up over the socket on the mother board and push the card down in to the socket. Press down on the
outer edge of the blue tab to lock the card in to place.
Note
To remove full-length expansion cards, unlock the retaining clip. To install full-length expansion
cards, lock the retaining clip.
Step 10
Replace the chassis cover.
Step 11
Slide the server back in to the rack by pressing the server rail-release handles.
Step 12
Reconnect the power cables to the IPS 4270-20.
Step 13
Power on the IPS 4270-20.
250204
3
45
6
78
9
P
C
I-
E
x
4
P
C
I-
E
x
8
P
C
I-
E
x
4
P
C
I-
E
x
8P
C
I
-
E
x
4
P
U
I
D
P
S
2