Filter
Top Products
6-18
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Chapter 6 Installing the IPS 4345 and IPS 4360
Removing and Installing the Power Supply
To remove and install the AC power supply, follow these steps:
Step 1
If you are adding an additional power supply, from the back of the appliance, push the lever on the slot
cover to the left to release it, grasp the handle of the slot cover and pull it away from the chassis
(Figure 6-12). Save the slot cover for future use. Continue with Step 3.
Figure 6-12 Removing the Slot Cover
Step 2
If you are replacing a power supply, follow these steps:
a.
Power off the appliance.
b.
From the back panel of the appliance, unplug the power supply cable.
c.
Push the lever on the power supply to the left and remove the power supply by grasping the handle
and then pulling the power supply away from the chassis while supporting it from beneath with the
other hand (Figure 6-13). Continue with Step 3.
Figure 6-13 Removing the AC Power Supply
331088
331089