Filter
Top Products
B-7
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Appendix B Initializing the Sensor
Advanced Setup
exit
service global-correlation
network-participation full
exit
[0] Go to the command prompt without saving this config.
[1] Return to setup without saving this config.
[2] Save this configuration and exit setup.
[3] Continue to Advanced setup.
Step 11
Enter
2
to save the configuration (or
3
to continue with advanced setup using the CLI).
Enter your selection[2]: 2
Configuration Saved.
Step 12
If you changed the time setting, enter
yes
to reboot the sensor.
For More Information
•
For the procedure for obtaining the most recent IPS software, see Obtaining Cisco IPS Software,
page C-1.
•
For the procedure for using HTTPS to log in to the IDM, refer to Logging In to the IDM.
•
For the procedures for configuring intrusion prevention on your sensor, refer to the following guides:
–
Cisco Intrusion Prevention System Device Manager Configuration Guide for IPS 7.1
–
Cisco Intrusion Prevention System Manager Express Configuration Guide for IPS 7.1
–
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 7.1
Advanced Setup
This section describes how to continue with Advanced Setup in the CLI for the various Cisco IPS
platforms. It contains the following sections:
•
Advanced Setup for the Appliance, page B-7
•
Advanced Setup for the ASA 5500 AIP SSM, page B-13
•
Advanced Setup for the ASA 5500-X IPS SSP, page B-17
•
Advanced Setup for the ASA 5585-X IPS SSP, page B-21
Advanced Setup for the Appliance
Note
The currently supported Cisco IPS appliances are the IPS 4240, IPS 4255, and IPS 4260 [IPS 7.0(x) and
later and IPS 7.1(5) and later], IPS 4270-20 [IPS 7.1(3) and later], IPS 4345 and IPS 4360 [IPS 7.1(3)
and later], and IPS 4510 and IPS 4520 [IPS 7.1(4) and later].