Filter
Top Products
Epson Research and Development Page 29
Vancouver Design Center
Interfacing to the Motorola ‘Dragonball’ Family of Microprocessors S1D13705
Issue Date: 01/02/13 X27A-G-007-04
4.4.3 MC68VZ328 Chip Select and Pin Configuration
The S1D13705 requires a 128K byte address space for the display buffer and its internal
registers. To accommodate this block size, it is preferable (but not required) to use one of
the chip selects from groups A or B. Groups A and B can have a size range of 128K bytes
to 16M bytes and groups C and D have a size range of 32K bytes to 16M bytes. Therefore,
any chip select other than CSA0 would be suitable for the S1D13705 interface.
In the example interface, chip select CSB1 is used to control the S1D13705. A 128K byte
address space is used with the S1D13705 control registers mapped into the top 32 bytes of
the 128K byte block and the 80K bytes of display buffer mapped to the starting address of
the block. The chip select should have its RO (Read Only) bit set to 0, its BSW (Bus Data
Width) set to 1 for a 16-bit bus, and the WS (Wait states) bit should be set to 111b to allow
the S1D13705 to terminate bus cycles externally with DTACK
. Enable DTACK pin
function with Register FFFFF433, Port G Select Register, bit 0.
Additional registers must be configured if the M68K #1 host bus interface is used. LDS
,
UDS
and R/W must be enabled by setting register FFFFFF443h bits 1, 2, and 3 to zero to
enable the internal 68000 pin functions.