Fujitsu FI-6800 Scanner User Manual


 
Index
Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Contents
TOP
120
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Various Ways
to Scan
Configuring
the Scan
Settings
How to Use
the Operator
Panel
3 Press the [iMFF] button and confirm that is displayed on
the LCD, and then press the [Scan] button or restart scanning
from the computer.
Note that, from hereon, in the LCD switches between shown/
hidden every time the [iMFF] button is pressed. According to the
mode specified, the scanner operates as explained below if
documents are scanned while is displayed.
z Manual mode (Bypass by front panel button)
The next sheet is scanned without multifeed detection, and after
the second sheet, multifeed errors are detected based on the
settings configured in the scanner driver or the Software Operation
Panel.
z Auto mode 1 (Bypass by combination of length and position)
The scanner memorizes the length and location of the paper
(overlap pattern) that caused a multifeed error and continues
scanning. When a paper attachment of a similar pattern is
detected, the scanner automatically ignores it to suppress
multifeed detection. (*1)(*2)
z Auto mode 2 (Bypass by length)
The scanner remembers the length of the paper (overlap pattern)
that caused a multifeed error and continues scanning. When a
paper attachment of the same length or shorter is detected, the
scanner automatically ignores it to suppress multifeed detection.
(*2)
*1: Up to eight overlap patterns can be memorized in this mode.
When the 9th overlap pattern is detected, the first pattern
that was memorized is erased from the memory.
*2: To erase the memorized overlap patterns and the longest
overlap length, press the [iMFF] and [Counter Reset]
buttons at the same time for more than two seconds while
[Ready] is displayed on the LCD. The LCD will display
or when the memory is erased. This
allows you to erase multifeed patterns and the longest
overlap length that were not supposed to be memorized. Be
careful with this operation because all memorized patterns
will be erased.
Multifeed patterns can also be erased from the Software
Operation Panel or [1: iMFF Setting] in the [Main Menu] of
the operator panel.