Filter
Top Products
Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
201
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Setting Automatic Detection for Color/
Monochrome [Auto color Detection]
Specify the slice level for Auto Color Detection.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 173).
2 From the listing on the left, select [Device Setting 2]
[Auto color Detection].
3 Select the slice value.
You can select the Slice value from 1 to 255.
Increase the value when black & white documents are recognized as
color documents. Decrease the value when color documents are
recognized as black & white documents.
z For information on how to configure the automatic
color/monochrome detection, refer to "Automatically
Detecting the Document Color (Color/Monochrome)"
(page 110).
z This setting does NOT appear when Kofax VRS is
used.