Filter
Top Products
Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
205
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Specifying the Sensitivity Level for Paper
Protection [Paper Protection Sensitivity]
You can specify the level of sensitivity to detect an abnormal
feeding of documents when Paper Protection is enabled.
Documents are deformed (e.g. warped, bent, creased) when
they are not being fed by the rollers properly. To detect such a
symptom and stop the scan, select [1: Low] to only detect
documents that are highly deformed, and [3: High] to also
detect documents that are slightly deformed.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 173).
2 From the listing on the left, select [Device Setting 2]
[Paper Protection Sensitivity].
3 Specify the sensitivity level for Paper Protection.
Low: Decreases the sensitivity level to detect warped
documents.
Normal: Monitors the documents in normal sensitivity. Keep this
setting for normal use.
High: Increases the sensitivity level to detect warped
documents.
z If a paper jam occurs at feeding position frequently,
select [Low].
z This setting can also be configured from the operator
panel. Note that you can prioritize the operator panel
setting.