Fujitsu FI-6800 Scanner User Manual


 
Index
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Contents
TOP
28
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
This section explains about the basic flow of scanning
operations.
In order to perform a scan, you need a scanner driver and an
application that supports the scanner driver.
This product bundles the TWAIN driver and the ISIS driver
(compliant to the respective standards), Kofax VRS, and an
application called "ScandAll PRO" which supports both drivers
and Kofax VRS.
1 Turn on the scanner.
For information on how to turn on the power, refer to "1.3 Turning the
Power ON/OFF" (page 17).
2 Load documents on the hopper.
Set the documents with the front side (scanning side) facing up.
For information on how to load documents, refer to "Chapter 2 How to
Load Documents" (page 33).
1.11 Basic Flow of Scanning Operation
z For details about the scanner drivers, refer to the following:
- "Chapter 3 Configuring the Scan Settings" (page 48)
- TWAIN Scanner Driver Help
- ISIS Scanner Driver Help
z For details about Kofax VRS, refer to:
- Kofax VRS Help
z For details about ScandAll PRO, refer to the following:
- ScandAll PRO V2.0 User's Guide
- ScandAll PRO Help
z When connected via SCSI, turn on the scanner and
confirm that [Ready] is displayed on the LCD before
you turn on the computer.
z When switching the connectors, make sure to power
off the scanner and the computer first.