Fujitsu FI-6800 Scanner User Manual


 
Index
Chapter 7 Replacing Consumables
Appendix
Glossary
Introduction
Contents
TOP
135
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing
Consumables
1 Remove all documents from the stacker.
2 Open the ADF.
For information on how to open the ADF, refer to "1.5 Opening/
Closing the ADF" (page 20).
3 Remove the pick rollers (×2) from the scanner.
1 Open the roller cover. Grab the tabs on the left and right side with
your fingers and pull down the cover towards you.
2 Pull the pick roller off the rotating shaft as you grab the tab on the
pick roller (×2).
4 Install a new set of pick rollers (×2) in the scanner.
1 Place the pick rollers (×2) on the shaft.
2 Close the roller cover. Make sure that both ends of the cover are
locked firmly.
7.2 Replacing the Pick Roller
There are two pick rollers. Make sure to replace both two units.
Be careful not to have your fingers caught
when the ADF closes.
Ta b
Roller Cover
Pick Roller