Fujitsu FI-6800 Scanner User Manual


 
Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
197
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Specifying the Number of Feeding Retries
[Number of paper feeding retries]
Configure this setting to change the number of feeding retries
upon pick errors.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 173).
2 From the listing on the left, select [Device Setting 2]
[Number of paper feeding retries].
3 Specify the number of paper feeding retries.
You can select from1 to 12 times.
Specifying the Interval to Feed the Documents
[Set the interval for feeding sheets]
If the scanned image is partially missing at the bottom due to a
large skew when scanning in Automatic Page Size Detection,
specify a longer interval to feed the documents to leave more
time between each document to be scanned.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 173).
2 From the listing on the left, select [Device Setting 2]
[Set the interval for feeding sheets].
3 Specify the paper feeding interval.
You can select from [Short (Default)] to [Long] (in four levels).
This setting can also be configured from the operator
panel.
Note that it takes more time for scanning as the paper
feeding interval becomes longer.