Fujitsu FI-6800 Scanner User Manual


 
Introduction
Chapter 2 How to Load Documents
Appendix
Glossary
Index
Contents
TOP
39
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
How to Load
Documents
5 Move the other hopper side guide to the target position
while pressing the side guide clutch.
In this case, slide the left hopper side guide as you press the side
guide clutch and leave no space between the hopper side guide and
the document.
6 Adjust the stacker extension to the document length, and
pull up the paper stop.
For information on how to set the stacker, refer to "1.8 Stacker
Setting" (page 24).
7 Start up an application for scanning and scan the
documents.
For information on how to scan using ScandAll PRO, refer to
"ScandAll PRO V2.0 User's Guide".
Hopper Side Guide
To unlock the hopper side guide, follow the steps below.
1 Slide down the side guide lock of the hopper side
guide that is locked.
2 Move both hopper side guides towards the center
while pressing the side guide clutches.
3 Release the side guide clutches.
Both hopper side guides will now move in
conjunction with each other.
unlocked
Side Guide
Lock
Side Guide
Clutch