Fujitsu FI-6800 Scanner User Manual


 
Introduction
Chapter 2 How to Load Documents
Appendix
Glossary
Index
Contents
TOP
44
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
How to Load
Documents
Conditions for Multifeed Detection
Multifeed is an error when two or more sheets are fed through
the ADF at once. It is also called a “multifeed” when a different
document length is detected.
Multifeed detection is performed by either checking the
overlapping of documents, length of the documents, or the
combination of both. The following conditions are required for
an accurate detection.
Detection by overlapping
z Load documents of the same thickness onto the hopper.
z Paper weight: 20 to 209.3 g/m
2
(5.5 to 56.1 lb)
/ 0.025 to 0.25 mm (0.001 to 0.010 in.)
z Do not punch holes within 35 mm (1.38 in.) of the vertical lines in the
left, center and right of the document. See Fig.1.
z Do not attach other documents within 35 mm (1.38 in.) of the vertical
lines in the left, center and right of the document. See Fig.1.
Detection by length
z Load documents of the same length onto the hopper.
z Variance in document lengths: 1% or less
z Do not punch holes within 35 mm (1.38 in.) over the vertical center
line of the document. See Fig. 2.
Detection by overlapping and length
z Load documents of the same thickness and the same length onto the
hopper.
z Paper weight: 20 to 209.3 g/m
2
(5.5 to 56.1 lb)
/ 0.025 to 0.25 mm (0.001 to 0.010 in.)
z Variance in document lengths: 1% or less
z Do not punch holes within 35 mm (1.38 in.) of the vertical lines in the
left, center and right of the document. See Fig.1.
z Do not attach other documents within 35 mm (1.38 in.) of the vertical
lines in the left, center and right of the document. See Fig.1.
Fig.1
Fig.2
The above condition applies when the document is set to the
center of the pick roller width.
z The rate of multifeed detection may drop with some
documents. Multifeed cannot be detected in the area of
15 mm from the leading edge of the document.
z The areas in Fig.1 can be changed in the Software
Operation Panel. For more details, refer to "9.5 Settings
Related to Multifeed Detection" (page 210).
35
6060
35 35
Feeding direction
Center of document
(Unit : mm)
Bottom of paper
Leading edge
Reference point
Front side
35
Feeding direction
Center of document
(Unit : mm)
Bottom of paper
Leading edge
Front side
Reference point