Fujitsu FI-6800 Scanner User Manual


 
Index
Introduction
Chapter 4 How to Use the Operator Panel
Appendix
Glossary
Contents
TOP
64
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Configuring
the Scan
Settings
About the Indicators
Paper Separation Force
Displays the paper separation
force as follows:
For information on how to
adjust the paper separation
force, refer to "1.9 Adjusting
the Paper Separation Force"
(page 26).
Icon Low High





iMFF Setting
Displays the iMFF setting as follows:
The icon switches when the [iMFF]
button is pressed down for more than
two seconds. In Manual mode,
is displayed at all times.
In Auto mode 1 and Auto mode 2, it
displays the number of multifeed
patterns memorized (max. of 8
patterns). For information on how to
configure the iMFF setting, refer to "4.2
Main Menu" (page 65).
Icon Mode
Manual mode
Auto mode 1
Auto mode 2
Multifeed Pattern Memory
appears when memorizing a multifeed pattern.
For information on how to memorize multifeed patterns, refer to
"Bypassing Multifeed Detection for a Fixed Format" (page 117).
[Send to/Pause] Button Configuration Number
Displays the number assigned to the application that is launched when
the [Send to/Pause] button is pressed. For information on how to
configure the [Send to/Pause] button, refer to "4.3 Function Selection"
(page 81).
MF Quick Change Setting
Displays whether or not to detect multifeed as follows:
The icon switches when the [Eject] button is pressed. Normally, one of
the above icons for “Normal” appears when [Enable(Detect)] or
[Enable(Ignore)] is specified. For information on how to configure the
MF Quick Change setting, refer to "4.2 Main Menu" (page 65). In Doc
Counting mode, one of the above icons for “Doc Counting Mode”
appears regardless of the MF Quick Change setting.
Icon Detection
method
Normal
Doc Counting Mode
Enable (Detect)
Enable (Ignore)
Information
appears when a message for replacing consumables/cleaning/
replacing maintenance parts/regular maintenance is displayed.
For instructions on when is displayed, refer to "4.2 Main Menu"
(page 65).
Prioritize Panel Settings
appears when the operator panel settings are prioritized.
For information on how to prioritize the operator panel settings, refer to
"4.2 Main Menu" (page 65).