Fujitsu FI-6800 Scanner User Manual


 
Index
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
177
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Item Description Setting/Value Factory Default SCSI or USB
Connector 1
SCSI or USB
Connector 2
3: Configurable
-: Not configurable
Multifeed Specify a method for multifeed
detection. Detect by monitoring the
overlapping, the document length,
or the combination of both.
It can also be configured from the
scanner driver’s setup dialog box.
Note that priority is given to the
scanner driver setting.
None / Check Overlapping (Ultrasonic) /
Check Length / Check Overlapping and
Length (when detecting from the length
difference, select from 10/15/20 mm)
Check
Overlapping
(Ultrasonic)
33
Multifeed detection
when scanning in
manual feeding
mode
Specify this item to enable multifeed
detection during manual feeding.
SCSI or USB Connector 1:
Disable / Follow driver settings
SCSI or USB Connector 2:
Disable / Follow Multifeed settings
Disable
33
Page Edge Filler
(ADF)
Specify a width for the margin off the
edge of the scanned image to fill in
black or white.
The margins are filled in white when
the background is white, and filled in
black when the background is black.
It can also be configured from the
scanner driver’s setup dialog box.
Note that the priority is given to the
setting with a larger value.
Top/Left/Right: 0 to 15 mm
Bottom: -7 to 7 mm (in increments of 1
mm)
(A: Image, B: Filled area, A+B: Output)
Top/Bottom/Left/
Right: 0 mm
3
-
Dropout color Select a color to be dropped out
from the scanned image (black &
white/grayscale only).
It can also be configured from the
scanner driver’s setup dialog box.
Note that priority is given to the
scanner driver setting.
Red / Green / Blue / None Green
3
-