Filter
Top Products
Index
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Contents
TOP
17
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
This section explains how to power on/off the scanner.
Turning the Power ON
Turn on the power in the following procedure:
1 Press the "|" side of the main power switch on the back.
2 Open the hopper.
For information on how to open the hopper, refer to "1.4 Opening/
Closing the Hopper" (page 19).
3 Press the power button on the front of the scanner.
The power is turned on, and the power button lights in blue.
Note that the following screen is displayed on the operator panel
LCD during initialization.
When [Ready] is displayed on the LCD, the scanner is ready to start
scanning.
1.3 Turning the Power ON/OFF
When connected via SCSI, turn on the scanner and confirm
that [Ready] is displayed on the LCD before you turn on the
computer.
Make sure to open the hopper before you press the power
button to turn on the scanner.
ONOFF
Power Button