Filter
Top Products
Index
Chapter 6 Daily Care
Appendix
Glossary
Introduction
Contents
TOP
125
How to Load
Documents
Configuring
the Scan
Settings
How to Use
the Operator
Panel
Various Ways
to Scan
Troubleshooting
Replacing
Consumables
Scanner
Overview
Daily Care
Operational
Settings
8 Press the [Scan] button.
The Cleaning Sheet is fed through and ejected onto the stacker.
9 Place the same Cleaning Sheet on the right-hand side
between the side guides with its adhesive side facing up.
10 Press the [Scan] button.
The Cleaning Sheet is fed through and ejected onto the stacker.
11 Remove the protective paper off a new Cleaning Sheet.
12 Place the Cleaning Sheet on the left-hand side between
the side guides with its adhesive side facing down.
13 Press the [Scan] button.
The Cleaning Sheet is fed through and ejected onto the stacker.
14 Place the same Cleaning Sheet on the right-hand side
between the side guides with its adhesive side facing
down.
15 Press the [Scan] button.
The Cleaning Sheet is fed through and ejected onto the stacker.
16 Press the [Stop] button.
Cleaning is completed.
17 Reset the cleaning counter.
Reset the counter by one of the following methods.
z Select [23: Show/Clear Counters] from the [Main Menu] on the
operator panel, then reset the counter.
For more details, refer to "4.2 Main Menu" (page 65).
z Start up the Software Operation Panel and reset the counter.
For more details, refer to "Resetting the counters" (page 186).
Adhesive side