Filter
Top Products
Periodic Maintenance Procedures
Each paper source has a Paper Pickup Roller that should be
replaced when paper no longer feeds reliably. The MP Tray (Tray
1) Paper Pickup Roller is shown in Figure 4-5. The PC tray (Tray
2) Pickup Roller is shown in Figure 4-7, the LC (Tray 3) Pickup
Roller is shown in Figure 4-8.
Removing the MP Tray (Tray 1) Pickup Roller
and Separation Pad
To remove and replace the MP (Tray 1) Pickup Roller and
Separation Pad, follow the steps below.
1
Turn OFF and unplug the printer.
2 Remove the MP Tray (Tray 1) inner black plastic cover.
3 Remove the roller by pinching the plastic retaining clip at the
side of the roller and sliding it off its shaft (see Figure 4-5).
(You may find it easiest to pinch the clip with your right hand
and use your left index finger to slide the roller to the right.)
Figure 4-5 Removing the MP Tray (Tray 1) Pickup Roller
Preventive Maintenance 4-11