Filter
Top Products
To Print Using the Infrared Port
The C2929A Infrared Transceiver must be plugged into the
infrared (IR) port on your HP LaserJet 5, 5M, or 5N printer,
located at the rear of the printer (Figure B-6). This port is
compliant with the specifications determined by the Infrared
Data Association (IrDA). On top of the transceiver pod is a status
light that indicates when the port is activated. To use the IR port,
you need to use a portable device that also includes an
IrDA-compliant IR port and be within the range of operation (see
Figure B-7).
The IR port is compatible with a wide variety of IrDA-compliant
portable devices; however, the method for printing will vary
depending on the type of device and the operating system in use.
Refer to the instruction manual for your portable equipment for
specific instructions on printing from that device.
The IR port works by receiving data similarly to a serial port,
however, without a cable and operates at speeds of up to 115 k
bits per second. When the IR connection is established, the status
light comes on. If the connection is broken or when the print job is
complete, the status light goes off.
1 Make sure the printer is in Ready Mode.
2 Align your laptop computer (or other portable equipment) that
is equipped with an IrDA-compliant IR port within 3 feet (1 m)
of the IR pod and at an angle of plus or minus 15 degrees to
ensure printing (Figure B-5).
Figure B-6 IrDA Port Location
B-36 LaserJet 5/5M/5N Printer