Filter
Top Products
NVRAM Init
NVRAM Init clears the NVRAM to its initial state. This reset is
used when the NVRAM becomes full and the user would like to
add additional personalities. It is possible to reconfigure the
NVRAM so the new personalities have higher priority and the
older personalities, while they can still be run with factory
defaults, run without NVRAM. This is done by clearing the
NVRAM and then adding the new personalities before adding the
older personalities.
To perform a NVRAM init, hold down the JOB CANCEL key
while power cycling the printer. The English message, “NVRAM
INIT” will be displayed briefly and the NVRAM will be initialized
before the rest of the system comes up. Once the power-on self
test is finished, the message “RESTORING FACTORY
SETTINGS” will scroll.
Note
The NVRAM init set the page count back to zero
and all other SERVICE MODE settings to
defaults, so it is necessary to reconfigure after
performing this initialization. It also sets the
Tray 1 size to Letter, the envelope feeder to
COM10, and the display language to English.
LaserJet 5/5M/5N Printer B-31