Filter
Top Products
Note
Refer to the “Product Family Compatibility
Matrix” in Chapter 1, or for the LaserJet 5,
Appendix B to verify correct memory for the
printer.
Message Symptoms and Recommendations
53.XY.ZZ ERROR An error occurred during configuration and validation of
SIMM memory:
X Hardware Type:
0:ROM
1:RAM
2:Flash
Y Hardware Device:
0: Internal Memory
1: SIMM Slot 1
2: SIMM Slot 2
3: SIMM Slot 3
4: SIMM Slot 4
ZZ Error Number:
0: Unsupported Memory
1: Unrecognized Memory
2: Unsupported Memory Size
3: Failed RAM Test
4: Exceeded Maximum RAM Size
5: Exceeded Maximum ROM Size
6: Invalid SIMM Speed
7: SIMM Reporting Information Incorrectly
8: SIMM RAM Parity Error
LaserJet 4/4m only
9: SIMM ROM Needs To Be Mapped To An Unsupported
Address
10:SIMM Address Conflict
11:PDC XROM out of bounds
12:Could not make a temporary mapping
Replace the SIMM device that caused the error. Pressing
[Continue]* allows you to continue but the SIMM device that
caused the error is not configured. If the SIMM device has
more than one bank of memory, the good banks are
configured.
*Press Go on the LJ5.
Table 7-1
Printer Messages (continued)
7-6 Troubleshooting