Filter
Top Products
Message Displayed Meaning
W1 IMAGE ADAPT
MEMORY LOW, PAGE
SIMPLIFIED
The printer received a graphics print file that was too
complex to print at the requested resolution. The printer
automatically processed the file in the highest resolution
possible with the memory installed. Add additional memory
to print the file at full resolution. Check the printout for loss
of data or print quality.
W2 INVALID PERS
REQUESTED LANGUAGE
NOT AVAILABLE
The job was not printed because the requested personality,
such as PostScript, was not installed. Install the language in
which the files are sent, together with enough memory to
support that language.
W3 JOB ABORTED
INSUFFICIENT MEMORY
JOB CLEARED
The printer was forced to abort the print job because there
was not enough installed memory to support the printer
language used.
W4 JOB 300/OFF
W5 JOB 300/LTR
W6 JOB 300/A4
W7 JOB 300/LGL
The job was printed at 300 dpi with page protection set as
specified in the message. To print the job as requested,
install additional memory.
W8 JOB 600/OFF
W9 JOB 600/LTR
W0 JOB 600/A4
The job was printed at 600 dpi with page protection set as
specified in the message. To print the job as requested,
install additional memory.
WM MEM CNFIG N/A
MEMORY SETTINGS
CHANGED
The printer did not have enough memory when switched on
to support the previous settings for I/O buffering and /or
Resource Saving, probably because you removed a
memory SIMM, added a new personality SIMM, or added
the optional duplex unit.
WM CHK MEM CNFIG
MEMORY SETTINGS
CHANGED
I/O Buffering and /or Resource Saving settings were altered
when the printer was switched on because the printer did
not have enough memory. This usually occurs after memory
has been removed from the printer. (You can check settings
by printing a self test.)
WM [personality]
MEM FULL
[personality]
MEMORY FULL
The Resource Saving memory area for the specified
personality is full. Press [CONTINUE]* to continue printing
(some data will be lost). The current job will print, but some
resources (downloaded fonts, etc.) may not be saved. If this
error occurs frequently, you may need to adjust Resource
Saving settings.
*Press Go on the LJ5.
Table 7-2
Clearable Warning Messages
Troubleshooting 7-11