Filter
Top Products
Interconnect PCA Removal
The Interconnect PCA is a connector board that connects the
Power Supply and the DC Controller with the the Fuser
Assembly. The Fuser Assembly connects directly into the
Interconnect PCA. The Power Supply and the DC Controller have
wiring harnesses that connect them to the Interconnect PCA.
Note
Re-assembly of the the Interconnect PCA requires
a small tie-wrap. Be sure to have a tie-wrap
available before beginning the disassembly.
Remove the interconnect as follows:
1 Remove the Formatter Cage, the Power Supply, the Fuser
Assembly, the High Voltage Power Supply, and the Rear Door.
2 Remove the (1) screw from the right-side PC tray Rail
Cover (see Figure 6-58, callout 1).
3 Release the latch (see Figure 6-58, callout 2), slide the Rail
Cover to the rear of the printer and remove the cover.
(continued on next page)
Figure 6-58 Right Side PC tray Rail Cover (printer on right
side)
6-69 Removal and Replacement