IXF1104 Quad-Port 10/100/1000 Mbps Ethernet Media Access Controller
Datasheet 65
Document Number: 278757
Revision Number: 007
Revision Date: March 25, 2004
5.0 Functional Descriptions
5.1 Media Access Controller (MAC)
The IXF1104 main functional block consists of four independent 10/100/1000 Mbps Ethernet
MACs, which support interfaces for fiber and copper connectivity.
• Copper Mode:
— RGMII for 10/100/1000 Mbps full-duplex operation and 10/100 Mbps half-duplex
operation
— GMII for 1000 Mbps full-duplex operation
• Fiber Mode:
— Integrated SerDes/OMI interface for direct connection to optical modules
— 1000 Mbps full-duplex operation in fiber mode
The following features support copper and fiber modes:
• Programmable Options:
— Automatic padding of transmitted packets that are less than the minimum frame size
— Broadcast, multicast, and unicast address filtering on frames received
— Filter and drop packets with errors
— Pre-padded RX frames with two bytes (aligns the Ethernet payload on SPI3 and in
network processor memories)
— Remove CRC from RX frames
— Append CRC to transmitted frames
• Performance Monitoring and Diagnostics:
— Loopback modes
— Detection of runt and overly large packets
— Cyclic Redundancy Check (CRC) calculation and error detection
— RMON statistics for dropped packets, packets with errors, etc.
• Compliant with IEEE Spec 802.3x standard for flow control
— Receive and execute PAUSE Command Frames
• Support for non-standard packet sizes up to 10 KB including loss-less flow control
Note: The IXF1104 does not support 10/100 Mbps operation when configured in GMII mode
The MAC is fully integrated, designed for use with Ethernet 802.3 frame types, and compliant to
all of the IEEE 802.3 MAC requirements.
The MAC adds preamble and Start-of-Frame Delimiter (SFD) to all frames sent to it (transmit
path) and removes preamble and SFD on all frames received by it (receive path). A CRC check is
also applied to all transmit and receive packets. CRC is optionally appended to transmit packets.