Filter
Top Products
Configuring PoE port parameters using the CLI 161
•
"poe poe-shutdown command" (page 161)
•
"poe poe-priority command" (page 162)
•
"poe poe-limit command" (page 163)
no poe-shutdown command
The no poe-shutdown command enables power to the port. The syntax
for the no poe-shutdown command is:
no poe-shutdown [port <portlist>]
The no poe-shutdown command is executed in the Interface
Configuration command mode.
Table 36 "no poe-shutdown command parameters and variables" (page
161) describes the parameters and variables for the no poe-shutdown
command.
Table 36
no poe-shutdown command parameters and variables
Parameters and
variables
Description
port <portlist>
Enter the port numbers on which you want to enable
power.
The default value is enabled.
ATTENTION
If you omit this parameter, the system uses the
port entered with the interface FastEthernet
command.
poe poe-shutdown command
The poe poe-shutdown command disables power to the port. The syntax
for the poe poe-shutdown command is:
poe poe-shutdown [port <portlist>]
The poe poe-shutdown command is executed in the Interface
Configuration command mode.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.