Filter
Top Products
Setting time on network elements using Simple Network Time Protocol 209
Figure 73
show sntp command output
sntp enable command
ATTENTION
The default setting for SNTP is disabled.
The sntp enable command enables SNTP. The syntax for the sntp
enable command is:
sntp enable
The sntp enable command is executed in the Global Configuration
command mode.
The sntp enable command has no parameters or variables.
no sntp enable command
The no sntp enable command disables SNTP. The syntax for the no
sntp enable command is:
no sntp enable
The no sntp enable command is executed in the Global Configuration
command mode.
The no sntp enable command has no parameters or variables.
sntp server primary address command
The sntp server primary address command specifies the IP
addresses of the primary NTP server. The syntax for the sntp server
primary address command is:
sntp server primary address <A.B.C.D>
The sntp server primary address command is executed in the
Global Configuration command mode.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.