Filter
Top Products
190 System configuration using the CLI
Parameters and
variables
Description
filename <WORD>
Specifies the file name.
ATTENTION
If you omit this parameter and do not specify BootP, the system
uses the configured file name.
address <XXX.XXX.XXX.X
XX>
Specifies the TFTP server from which to load the file. Enter the IP
address in dotted-decimal notation.
ATTENTION
If you omit this parameter and do not specify BootP, the system
uses the configured address.
ATTENTION
When you specify the file name or address, these parameters change at the next
reboot, even if you do not specify load-on-boot.
show config-network command
The show config-network command displays information regarding
the automatic loading of the configuration file, including the current status
of this feature, the file name, the TFTP server address, and the status of
the previous automatic configuration command. The syntax for the show
config-network command is:
show config-network
The show config-network command is executed in the Privileged
EXEC command mode.
The show config-network command has no parameters or values.
Figure 61 "show config-network command output" (page 191) shows the
output for the show config-network command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.