Filter
Top Products
92 CLI Basics
The interface command is executed in the Global Configuration
command mode.
Table 12 "interface command parameters and variables" (page 92) describes
the parameters and variables for the interface command.
Table 12
interface command parameters and variables
Parameters
and variables
Description
<portlist> Specifies the portlist you want to be affected by all the
commands issued in the config-if command mode.
disable command
The disable command returns you to the User EXEC (exec) command
mode. The syntax for the disable command is:
disable
The disable command is executed in the Privileged EXEC command
mode.
The disable command has no parameters or variables.
end command
The end command moves you to the priv Exec mode from either the Global
Configuration (config) mode or the Interface Configuration (config-if) mode.
The syntax for the end command is:
end
The end command has no parameters or variables.
exit command
The exit command moves you around the command modes:
•
In User EXEC (exec) and Privileged EXEC (privExec) command modes,
exit lets you quit the CLI session.
•
In Global Configuration (config) mode, exit moves you back to the
privExec command mode.
• In Interface Configuration (config-if) command mode, exit moves you
back to the Global Configuration command mode.
The syntax for the exit command is:
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.