Filter
Top Products
Upgrading software 229
Figure 85
show lldp port tx-tlv command output
Configuring LEDs to blink on the display panel
With the blink-leds command, you can set the LEDs on the display
panel to blink to identify a particular unit. The syntax for the blink-leds
command is:
blink-leds [off | time <1-10>]
The blink-leds command is executed in the Privileged EXEC command
mode.
Table 89
blink-leds command parameters and variables
Parameters and
variables
Description
off Sets the LEDs to stop blinking.
time <1-10> Indicates the duration, in minutes, for the LEDs to blink
in order to identify the unit.
Upgrading software
You can download the Ethernet Routing Switch 2500 Series software image
that is located in nonvolatile flash memory. To download the Ethernet
Routing Switch 2500 Series software image, a properly configured Trivial
File Transfer Protocol (TFTP) server must be present in your network, and
the Ethernet Routing Switch 2500 Series must have an IP address. To
learn how to configure the switch IP address, see "Assigning and clearing
IP addresses" (page 178).
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.