Filter
Top Products
218 System configuration using the CLI
•
"no lldp config-notification command" (page 220)
•
"default lldp config-notification command" (page 220)
•
"lldp tx-tlv command" (page 221)
•
"no lldp tx-tlv command" (page 221)
•
"default lldp tx-tlv command" (page 222)
•
"lldp status command" (page 222)
•
"no lldp status command" (page 223)
•
"default lldp status command" (page 223)
•
"show lldp command" (page 224)
•
"show lldp port command" (page 226)
lldp command
The lldp command sets the LLDP transmission parameters. The syntax
for the lldp command is:
lldp [tx-interval <5-32768>] [tx-hold-multiplier <2-10>]
[reinit-delay <1-10>] [tx-delay <1-8192>]
[notification-interval <5-3600>]
The lldp command is executed in the Global Configuration command
mode.
Table 76 "lldp command parameters and variables" (page 218) describes
the parameters and variables for the lldp command.
Table 76
lldp command parameters and variables
Parameters and
variables
Description
tx-interval
<5-32768>
Sets the interval between successive transmission cycles.
tx-hold-multiplier
<2-10>
Sets the multiplier for tx-interval used to compute the Time
To Live value for the TTL TLV.
reinit-delay
<1-10>
Sets the delay for re-initialization attempt if the adminStatus
is disabled.
tx-delay <1-8192
>
Sets the minimum delay between successive LLDP frame
transmissions.
notification-interva
l <5-3600>
Sets the interval between successive transmissions of LLDP
notifications.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.