Filter
Top Products
Configuring LLDP using the CLI 221
lldp tx-tlv command
The lldp tx-tlv command specifies the optional TLVs to include in the
transmitted LLDPDUs. The syntax for the lldp tx-tlv command is:
lldp tx-tlv [port <portlist>] [local-mgmt-addr] [port-desc]
[sys-cap] [sys-desc] [sys-name]
The lldp tx-tlv command is executed in the Interface Configuration
command mode.
Table 81 "lldp tx-tlv command parameters and variables" (page
221) describes the parameters and variables for the lldp tx-tlv command.
Table 81
lldp tx-tlv command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the ports affected by the command.
local-mgmt-addr Local management address TLV
port-desc Port description TLV
sys-cap
System capabilities TLV
sys-desc System description TLV
sys-name
System name TLV
no lldp tx-tlv command
The no lldp tx-tlv command specifies the optional TLVs not to include
in the transmitted LLDPDUs. The syntax for the lldp tx-tlv command is:
no lldp tx-tlv [port <portlist>] [local-mgmt-addr]
[port-desc]
[sys-cap] [sys-desc] [sys-name]
The no lldp tx-tlv command is executed in the Interface Configuration
command mode.
Table 82 "no lldp tx-tlv command parameters and variables" (page
221) describes the parameters and variables for the no lldp tx-tlv command.
Table 82
no lldp tx-tlv command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the ports affected by the command.
local-mgmt-addr Local management address TLV
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.