Filter
Top Products
180 System configuration using the CLI
The no ip netmask command is executed in the Global Configuration
command mode.
The no ip netmask command has no parameters or variables .
ip default-gateway command
The ip default-gateway command sets the IP default gateway address
for a switch. The syntax for the ip default-gateway command is:
ip default-gateway <XXX.XXX.XXX.XXX>
The ip default-gateway command is executed in the Global
Configuration command mode.
Table 48 "ip default-gateway command parameters and variables" (page
180) describes the parameters and variables for the ip default-gateway
command.
Table 48
ip default-gateway command parameters and variables
Parameters and
variables
Description
XXX.XXX.XXX.XXX Enter the dotted-decimal IP address of the default IP
gateway.
ATTENTION
When you change the IP gateway, you may lose connection to Telnet and the Web.
no ip default-gateway command
The no ip default-gateway command sets the IP default gateway
address to zeros (0). The syntax for the no ip default-gateway
command is:
no ip default-gateway
The no ip default-gateway command is executed in the Global
Configuration command mode.
The no ip default-gateway command has no parameters or variables.
ATTENTION
When you change the IP gateway address, you may lose connection to Telnet and
the Web. You also may disable any new Telnet connection required to connect to
the serial Console port to configure a new IP Gateway address.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.