Filter
Top Products
242 Ethernet port management using the CLI
Table 101
no flowcontrol command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to disable flow control.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
default flowcontrol command
The default flowcontrol command is used only on Gigabit Ethernet
ports and sets the flow control to auto, which automatically detects the flow
control. The syntax for the default flowcontrol command is:
default flowcontrol [port <portlist>]
The default flowcontrol command is executed in the Interface
Configuration command mode.
Table 102 "default flowconrtol command parameters and variables" (page
242) describes the parameters and variables for the default flowcontrol
command.
Table 102
default flowconrtol command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to default to auto flow
control.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
Enabling rate-limiting
You can limit the percentage of multicast traffic, or broadcast traffic, or both
using the CLI.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.