Filter
Top Products
206 System configuration using the CLI
The write memory command is executed in the Privileged EXEC
command mode.
The write memory command has no parameters or variables.
save config command
The save config command copies the current configuration to NVRAM.
The syntax for the save config command is:
save config
The save config command is executed in the Privileged EXEC command
mode.
The save config command has no parameters or variables.
Enabling and disabling autosave
The Ethernet Routing Switch 2500 Series performs a check every 60
seconds to detect changes in the configuration file or a new log message
in the nonvolatile storage. If any of these two events occurs, the switch
automatically saves its configuration and the nonvolatile log to flash
memory. Autosave also automatically saves your configuration information
across reboots.
You can enable or disable this feature. When you disable autosave, changes
in the configuration file are not saved to the flash memory.
This section contains information about the following commands:
•
"show autosave command" (page 206)
•
"autosave enable command" (page 207)
• "no autosave enable command" (page 207)
•
"default autosave enable command" (page 207)
ATTENTION
You can use the CLI command copy config nvram to force a manual save of
the configuration when autosave is disabled.
show autosave command
The show autosave command displays the status of the autosave feature,
either enabled or disabled. The syntax for the show autosave command
is:
show autosave
The show autosave command is executed in the Privileged EXEC
command mode.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.