Filter
Top Products
202 System configuration using the CLI
no banner command
The no banner command lets you clear all lines of a previously stored
custom banner. The syntax for the no banner command is:
no banner
The no banner command is executed in the Global Configuration
command mode.
Displaying the ARP table
The show arp-table command displays the arp table of the device. The
syntax for the show arp-table command is:
show arp-table
The show arp-table command is executed in the User Exec command
mode.
The show arp-table command has no parameters or variables.
Figure 67 "show arp-table command output" (page 202) displays a sample
output of the show arp-table command.
Figure 67
show arp-table command output
Displaying interfaces
You can view the status of all interfaces on the switch, including MultiLink
Trunk membership, link status, autonegotiation, and speed. This section
contains information about the following:
•
"show interfaces command" (page 202)
•
"show interfaces config command" (page 204)
show interfaces command
The show interfaces command displays the current configuration and
status of all interfaces. The syntax for the show interfaces command is:
show interfaces [names | gbic-info] [<portlist>]
The show interfaces command is executed in the User Exec command
mode.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.