Filter
Top Products
Configuring LLDP using the CLI 219
default lldp command
The default lldp command sets the LLDP transmission parameters to
their default values. The syntax for the default lldp command is:
default lldp [tx-interval] [tx-hold-multiplier]
[reinit-delay] [tx-delay] [notification-interval]
If no parameters are specified, the default lldp command sets all
parameters to their default values.
The default lldp command is executed in the Global Configuration
command mode.
Table 77 "default lldp command parameters and variables" (page
219) describes the parameters and variables for the default lldp command.
Table 77
default lldp command parameters and variables
Parameters and
variables
Description
tx-interval
Sets retransmit interval to the default value (30).
tx-hold-multiplier Sets transmission multiplier to the default value (4).
reinit-delay Sets reinitialize delay to the default value (2).
tx-delay Sets transmission delay to the default value (2).
notification-interva
l
Sets notification interval to the default value (5).
lldp config-notification command
The lldp config-notification command enables notification when
new neighbor information is stored or when existing information is removed.
The syntax for the lldp config-notification command is:
lldp [port <portlist>] config-notification
The lldp config-notification command is executed in the Interface
Configuration command mode.
Table 78 "lldp config-notification command parameters and variables" (page
220) describes the parameters and variables for the lldp config-notification
command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.