Filter
Top Products
200 System configuration using the CLI
copy tftp config command
The copy tftp config command retrieves the system configuration file
from the TFTP server and uses the retrieved information as the current
configuration on the system.The syntax for the copy tftp config
command is:
copy tftp config [address <XXX.XXX.XXX.XXX>] filename <WORD>
The copy tftp config command is executed in the Privileged EXEC
command mode.
Table 64 "copy tftp config command parameters and variables" (page
200) describes the parameters and variables for the copy tftp config
command.
Table 64
copy tftp config command parameters and variables
Parameters and
variables
Description
address <XXX.XXX.X
XX.XXX>
Specifies the TFTP server IP address; enter in
dotted-decimal notation.
filename <WORD> Enter the name of the configuration file you want to copy
from the TFTP server.
Customizing the opening banner
You can customize the banner that appears when you connect to the
Ethernet Routing Switch 2500 Series. You can customize the text that reads
NORTEL. However you cannot customize the second line that reads Enter
[Ctrl]+y to begin.
The Banner Control feature provides an option to specify the banner text.
If you choose not to display the banner, the system enters the command
mode through the default command interface. You do not have to press
the Ctrl+y keys.
The Banner display that you select is used for subsequent console sessions.
For executing the new mode in the console, you must logout. For Telnet
access, all subsequent sessions use the selected mode.
This section contains information about the following commands:
•
"banner command for displaying banner" (page 201)
•
"show banner command" (page 201)
•
"no banner command" (page 202)
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.