Filter
Top Products
343
Appendix B
Default settings
The following table lists the factory default settings for the Ethernet Routing
Switch 2500 Series.
Table 155
Factory default settings
Field Default setting
BootP Request Mode BootP or Default IP
In-Band Switch IP Address
192.168.1.1
In-Band Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
(no IP address assigned)
Read-Only Community String public
Read-Write Community String private
Trap IP Address
0.0.0.0
(no IP address assigned)
Community String Zero-length string
Autotoplology Enabled
Authentication Trap Enabled
Link Up/Down Trap Enabled
Reset Count 1 (This is the value only when the flash memory
is erased. Even if you reboot the switch to factory
defaults, the Reset Count increases and is equal to the
number of times the switch restarted from the last flash
memory erase.)
Last Reset Type Power Cycle
sysContact Zero-length string
sysName Zero-length string
sysLocation Zero-length string
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.