Filter
Top Products
260 Configuring the switch using Device Manager
The following table describes the System tab fields.
Table 117
System tab fields
Field Description
sysDescr The assigned system description.
sysUpTime The time since the system was last booted.
sysObjectID The unique sysObjectID (OID) assigned to the device.
sysContact Type the contact information (in this case, an e-mail
address) for the system administrator.
sysName Type the name of this device.
sysLocation Type the physical location of this device.
SerNum The switch serial number.
AuthenticationTraps Click to enable or disable. When you enable, SNMP
traps are sent to trap receivers for all SNMP access
authentication. When you disable, no traps are received.
To view traps, click the Trap toolbar button.
ReBoot By default, the switch is in the Running mode. The
reboot command initiates a hardware reset.
AutoPVID Click to enable or disable. When you enable, AutoPVID
is activated. When you disable, AutoPVID is inactivated.
ManagementVlanId The current management VLAN ID.
StackInsertionUnitNu
mber
This field specifies the unit number to be assigned to the
next unit that joins the stack, when in stack mode.
AutoUnitReplacement
Enabled
Click to enable or disable the auto-unit-replacement
feature.
NextBootMgmt
Protocol
The transport protocol(s) to use after the next boot of
the agent.
CurrentMgmtProtocol The current transport protocol(s) that the agent supports.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.