Filter
Top Products
Configuring LLDP using Device Manager 281
Figure 99
Diagnostics dialog box Topology Table tab
—End—
The following table describes the Topology Table tab fields.
Table 127
Topology Table tab fields
Field Description
Slot The slot number in the chassis in which the topology message
was received.
Port The port on which the topology message was received.
IpAddr The IP address of the sender of the topology message.
SegId The segment identifier of the segment from which the remote
agent sent the topology message. This value is extracted from
the message.
MacAddr The MAC address of the sender of the topology message.
ChassisType The chassis type of the device that sent the topology message.
BkplType The backplane type of the device that sent the topology
message.
LocalSeg Indicates if the sender of the topology message is on the same
Ethernet segment as the reporting agent.
CurState The current state of the sender of the topology message. The
choices are:
•
topChanged—Topology information has recently changed.
•
heartbeat—Topology information is unchanged.
• new—The sending agent is in a new state.
Configuring LLDP using Device Manager
Use the following tabs to configure LLDP properties for local and neighbor
systems:
•
"LLDP Globals tab" (page 282)
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.