Filter
Top Products
326 Configuring the switch using web-based management
Item Range Description
Alias Displays the name, or alias, you assigned the port. To
assign or change the name, enter up to 26 alphanumeric
characters.
Trunk The trunk group that the switch port belongs to as specified
in the Trunk Member fields on the MultiLink Trunk page.
Status (1) Enabled
(2) Disabled
Choose to enable or disable the port. You can also use this
field to control access to any switch port.
The default setting is Enabled.
Link The current link state of the corresponding port as follows:
Up: The port is connected and operational
Down: The port is not connected or is not operational.
Link Trap (1) On
(2) Off
Choose to control whether link up/down traps are sent to
the configured trap receiver from the switch.
The default setting is On.
Autonegotiation (1) Enabled
(2) Disabled
Choose to enable or disable the autonegotiation feature.
Choosing to enable autonegotiation sets the
corresponding port speed to match the best service
provided by the connected station, up to 100Mb/s in
full-duplex mode.
ATTENTION
Autonegotiation also enables auto sensing on 10/100
ports.
The default setting is Enabled.
Speed / Duplex (1) 10Mbs / Half
(2) 10Mbs / Full
(3) 100Mbs / Half
(4) 100Mbs / Full
(5) 1000Mbs / Full
Lets you manually configure any port to support a specific
Ethernet speed and duplex setting.
The default setting is 10 Mbs/Half when autonegotiation is
disabled and 1000 Mb/s full-duplex for gigabit ports only.
2
In the port row of your choice, select from the lists.
3
Click Submit.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.