Filter
Top Products
Setting port speed 237
Table 95
default name command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to clear of names.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
Setting port speed
You can set the speed and duplex mode for a port. This section covers:
•
"speed command" (page 237)
•
"default speed command" (page 238)
•
"duplex command" (page 239)
•
"Enabling or disabling a port" (page 233)
speed command
The speed command sets the speed of the port. The syntax for the speed
command is:
speed [port <portlist>] {10|100|1000|auto}
The speed command is executed in the Interface Configuration command
mode.
Table 96 "speed command parameters and variables" (page 237) describes
the parameters and variables for the speed command.
Table 96
speed command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to configure the speed.
Enter the port numbers you want to configure.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.