Filter
Top Products
90 CLI Basics
Figure 24
help command output
no command
The no command is always used as a prefix to a configuration command,
and it negates the action performed by that command. The effect of the
no command is to remove or to clear the configuration controlled by the
specified command. Various no commands are in the config and config-if
command modes.
See Appendix "Command List" (page 353) for an alphabetical listing of all
no commands.
ATTENTION
Not all configuration commands support the no prefix command.
default command
The default command is always used as a prefix to a configuration
command, and it restores the configuration parameters to default values.
The default values are specified by each command.
See Appendix A for an alphabetical listing of all default commands.
ATTENTION
Not all commands support the default prefix command.
logout command
The logout command logs you out of the CLI session. The syntax for the
logout command is:
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.