Filter
Top Products
Setting port speed 239
duplex command
The duplex command specifies the duplex operation for a port. The syntax
for the duplex command is:
duplex [port <portlist>] {full|half|auto}
The duplex command is executed in the Interface Configuration command
mode.
Table 98 "duplex command parameters and variables" (page 239) describes
the parameters and variables for the duplex command.
Table 98
duplex command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port number to configure the duplex
mode. Enter the port number you want to configure,
or all to configure all ports simultaneously.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
full|half|auto
Sets duplex to:
•
full—full-duplex mode
•
half—half-duplex mode
•
auto—autonegotiation
ATTENTION
When you set the duplex mode for autonegotiation, ensure that the other side of
the link is also set for autonegotiation.
default duplex command
The default duplex command sets the duplex operation for a port to
the factory default duplex value. The syntax for the default duplex
command is:
default duplex [port <portlist>]
The default duplex command is executed in the Interface Configuration
command mode.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.