Filter
Top Products
204 System configuration using the CLI
The following figure shows a sample output of the show interfaces verbose
command.
Figure 70
show interfaces verbose command output
show interfaces config command
The show interfaces config command displays the current
operational status of interfaces and provides supplementary information
about the current port settings for Spanning Tree Protocol.
The syntax for the show interfaces config command is:
show interfaces [<portlist>] config
The show interfaces config command is executed in the Privileged
EXEC command mode.
Table 68 "show interfaces config command parameters and variables"
(page 204) describes the parameters and variables for the show interfaces
config command.
Table 68
show interfaces config command parameters and variables
Parameters
and
variables
Description
<portlist> Enter the ports you want to display.
Figure 71 "show interfaces config command output" (page 205) displays a
sample output of the show interfaces config command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.