Filter
Top Products
Saving the configuration to NVRAM 205
Figure 71
show interfaces config command output
Saving the configuration to NVRAM
You can save your configuration parameters to Non-Volatile RAM (NVRAM)
using any of the following CLI commands:
•
"copy config nvram command" (page 205)
•
"write memory command" (page 205)
• "save config command" (page 206)
copy config nvram command
The copy config nvram command copies the current configuration to
NVRAM. The syntax for the copy config nvram command is:
copy config nvram
The copy config nvram command is executed in the Privileged EXEC
command mode.
The copy config nvram command has no parameters or variables.
ATTENTION
The system automatically issues the copy config nvram command
periodically. See "Enabling and disabling autosave" (page 206) for details.
write memory command
The write memory command copies the current configuration to NVRAM.
The syntax for the write memory command is:
write memory
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.