Filter
Top Products
Customizing your system 197
Table 61
ip bootp server command parameters and variables
Parameters and
variables
Description
last|needed|disable|al
ways
Specifies when to use BootP:
•
default-ip—use BootP or the default IP
• last—use BootP or the last known address
•
disable—never use BootP
•
always—Always use BootP
no ip bootp server command
The no ip bootp server command disables the BootP server. The
syntax for the no ip bootp server command is:
no ip bootp server
The no ip bootp server command is executed in the Global
Configuration command mode.
The no ip bootp server command has no parameters or values.
default ip bootp server command
The default ip bootp server command sets the BootP server status
to BootP or Default IP. The syntax for the default ip bootp server
command is:
default ip bootp server
The default ip bootp server command is executed in the Global
Configuration command mode.
The default ip bootp server command has no parameters or values.
Setting TFTP parameters
You can display the IP address of the TFTP server, assign an IP address
you want to use for a TFTP server, copy a configuration file to the TFTP
server, or copy a configuration file from the TFTP server to the switch to use
to configure the switch. This section covers:
•
"show tftp-server command" (page 198)
•
"tftp-server command" (page 198)
•
"default tftp-server command" (page 199)
•
"no tftp-server command" (page 199)
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.