Filter
Top Products
240 Ethernet port management using the CLI
Table 99 "default duplex command parameters and variables" (page
240) describes the parameters and variables for the default duplex
command.
Table 99
default duplex command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to reset the duplex mode
to factory default values. Enter the port numbers
you want to configure, or all to configure all ports
simultaneously. The default value is autonegotiation.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
Enabling flow control
If you use a Gigabit Ethernet with the Ethernet Routing Switch 2500 Series,
you control traffic on this port using the flowcontrol command. This
section covers the following commands:
•
"flowcontrol command" (page 240)
•
"no flowcontrol command" (page 241)
•
"default flowcontrol command" (page 242)
flowcontrol command
The flowcontrol command is used only on Gigabit Ethernet ports
and controls the traffic rates during congestion. The syntax for the
flowcontrol command is:
flowcontrol [port <portlist>]
{asymmetric|symmetric|auto|disable}
The flowcontrol command is executed in the Interface Configuration
command mode.
Table 100 "flowcontrol command parameters and variables" (page
241) describes the parameters and variables for the flowcontrol command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.