Filter
Top Products
Configuring the switch IP address, subnet mask and default gateway 179
default ip address command
The default ip address command sets the IP address for the
specified unit to the default value as 192.168.1.1 for Standalone Mode and
192.168.1.2 for Stacking Mode. The syntax for the default ip address
command is:
default ip address
The default ip address command is executed in the Global
Configuration command mode.
no ip address command
The no ip address command clears the IP address and subnet mask.
This command sets the IP address and subnet mask for a switch to all zeros
(0). The syntax for the no ip address command is:
no ip address
The no ip address command is executed in the Global Configuration
command mode.
The no ip address command has no parameters or variables.
ATTENTION
When you change the IP address or subnet mask, you may lose connection to
Telnet and the Web. You also disable any new Telnet connection, and you must
connect to the serial Console port to configure a new IP address.
default ip netmask command
The default ip netmask command sets the subnet mask to the
default value (255.255.255.0). The syntax for the default ip netmask
command is:
default ip netmask
The default ip netmask command is executed in the Global
Configuration command mode.
The default ip netmask command has no parameters or variables .
no ip netmask command
The no ip netmask command sets the subnet mask for a switch to all
zeros (000.000.000.000). The syntax for the no ip netmask command
is:
no ip netmask
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.