Filter
Top Products
84 CLI Basics
Command
mode
Sample Prompt for
the Ethernet
Switch 2500
Enter/exit command
Privileged EXEC
(privExec)
2500T#
enable to enter from User
EXEC mode
logout or exit to quit to
Main Menu
Global
Configuration
(config)
2500T(config)#
configure to enter from
Privileged EXEC mode
end or exit to exit to
Privileged EXEC mode;
logout to quit to Main Menu
Interface
Configuration
(config-if)
2500T(config-if)# interface FastEthern
et {<portnum>|all}
to enter from Global
Configuration mode
logout to quit to Main Menu;
end to exit to Privileged
EXEC mode; exit to exit to
Global Configuration mode
The prompt displays the switch name, and the current CLI command mode.
For example:
•
User EXEC--2500T>
• Privileged EXEC--2500T#
•
Global Configuration--2500T(config)#
•
Interface Configuration--2500T(config-if)#
See Appendix "Command List" (page 353) for a complete, alphabetical list
of all CLI commands and where they are explained.
The initial command mode in CLI depends on your access level when you
logged into the Ethernet Routing Switch 2500 Series:
•
With no password protection, you can enter the CLI in userExec mode,
and use the enable command to move to the privExec command mode.
• If you have logged into the CLI with read-only access, you enter the CLI
in userExec mode and cannot access any other CLI command modes.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.